Akai LPK25 mk2 bare keybed for Otterchip Model M
Research note, 5 Nov 2026. This is a second Model M option. The SE25 design stays as it is.
Open the LPK25 Otterchip design ↗ · Open the existing SE25 design ↗
Installed comparison
The current LPK25 study starts at 355 mm body width and 91 mm deck height, compared with 388 mm and 97 mm for the conservative SE25 layout. The full wooden-wheel assemblies and front headphone connectors remain. The 6.35 mm connector beneath the keys is one reason the deck cannot simply drop to the earlier 66.5 mm concept.
The original LPK25 controller board is allocated a separate 40 × 80 × 20 mm space behind the keybed. That is a packaging allowance, not a measured board. Its buttons would need relocation or software controls, and the ribbon route around the left wheel needs a physical donor check.
Evidence classes
■ documented means it comes from manufacturer text. ■ photo estimate means pixels measured on teardown photos, scaled from the published 348 mm width. ■ inferred means the part exists but we could not see its shape or position. ■ proposal means an Otterchip allowance we chose.
Key numbers
| Quantity | Value | Range | Status |
|---|
What the teardown shows
- The mk2 keybed is a separate assembly. Ten screws, in a 5 × 2 arrangement, fix it to the red bottom plate. Eight more screws around the edge hold the top shell.
- Each key has its own close-wound coil spring at its tail. Their eyelets are visible from above. The author says the spring stretches when a key is struck. The model assumes the pivot sits in front of the spring row and reserves room for the key tails to rise about 1 mm when a key is pressed. This is an inference: the pivot does not appear in the photos.
- A flat ribbon runs to the left, to a small controller PCB next to the USB-B port. The keys sit about 13.6 mm right of the case centre.
- There is a contact PCB, but its position and contact type are not shown. The model draws it as an envelope only.
Limits
- The heights (white tops ≈ 20.5 mm, black tops ≈ 29 mm above the keybed underside) are bounded by the published 38 mm overall height and an oblique photo. Expect ±3 mm.
- The screw rows are approximate factory positions, ±4 mm. They assume the underside photo is mirrored, which is the only orientation that centres the screws on the keys. Thread and length are unknown.
- Front travel of 8 mm is a working estimate (range 6 to 10 mm).
- The 291 mm PCB figure from the MPK mini mk3 manual belongs to a different product. It is not used here.
Sources
- Sand, Software, Sound: “Inside Akai LPK25 mk2” (2023 teardown, photos)
- LPK25 mk2 User Guide, Technical Specifications (348 × 102 × 38 mm, 0.45 kg)
- Akai Pro LPK25 mk2 FAQ (spring and joint action)
- Retail listing (availability context only)
Data: OTTERCHIP_LPK25_GEOMETRY in otterchip-component-lpk25.js. Photos are linked, not re-hosted.