Body fit, typing & music
This is a geometric design study: a posed reference body, the computer’s current dimensions, and adjustable furniture. It helps reveal reach and clearance compromises. It does not establish a clinically safe age, predict comfort, or replace trying a physical prototype with its user.
Two activities, two comparisons
Typing reaches the typing key tops and accounts for the palm cushion when installed. Hands float while typing; the heel of the palm may rest on the cushion during pauses. OSHA palm-support guidance.
Music reaches the lower, more forward white keys, with the cover removed and a curved-finger starting pose. Relaxed arms, freely moving hands and elbows near key height are useful goals. The pose cannot represent all playing techniques, finger spans or key travel. Yamaha piano posture guidance.
Each activity has its own curve for wrist bend, forearm slope, viewing distance and other measurements. In Auto mode furniture is recalculated at every age; in Manual mode the same heights are used across the curves. Hollow points indicate a modeled fit conflict. A low wrist angle alone does not mean the whole pose fits.
What the body represents
Age presets run from 3 through 18, labeled Adult at 18. Reference height is the midpoint of the male and female median values in the CDC 2000 stature table, at the nearest half-month row for each birthday. This midpoint is our convenience preset, not a CDC population statistic.
Body segments use age-interpolated estimates, checked for plausibility against historical child measurements in Snyder et al., 1977, prepared for the CPSC. Entering actual height scales those estimates; it does not measure arm length, torso proportions or body build. The face, clothing, hair and soft tissue are illustrations. Joint positions and eye positions come from the same geometry that produces the displayed measurements.
Adult is a size reference, not a model of older-adult mobility or vision. The optional progressive/bifocal note addresses avoiding a tipped-back head when looking through a lens zone. No separate age-only “elderly” posture is assumed. OSHA workstation checklist.
Furniture and fit conflicts
Auto mode starts with feet supported, then searches for a reachable key position with a neutral wrist. It sets a table height that leaves modeled thigh/knee clearance where the body actually extends under the table. The tabletop is 26 mm thick. A 20 mm clearance margin and 15 mm shoe allowance are design assumptions, not prescribed values.
The keys’ height above the table can create a conflict: lowering the table to relax the arms may remove leg room. Raising the chair moves both elbows and knees. The viewer reports this compromise rather than stretching limbs or silently moving the computer. Manual heights can produce missed key targets, raised shoulders or other visibly poor poses; these remain visible.
A backrest and foot support help a seated setup. Observe the person’s movement and comfort, leave room behind the knees and vary posture. Cornell’s child workstation guidance provides useful expert recommendations; its numeric suggestions are not a validated age-suitability score.
Reading the measurements
| Measurement | Definition |
|---|---|
| View distance | Eye midpoint to the center of the display. |
| Gaze | Line of sight to display center, measured down from horizontal. |
| Head tilt | Modeled head pitch relative to the trunk. This simplified joint is not a measurement of individual cervical vertebrae. |
| Wrist bend | Palm axis relative to the forearm; finger curl is separate. Positive means extension, negative means flexion. |
| Elbow angle | Included angle between upper arm and forearm. |
| Forearm slope | Forearm angle above horizontal, positive when the hand is higher than the elbow. |
| Keys above neutral | Difference between the actual and ideal table height for a horizontal forearm, neutral wrist and the activity’s assumed finger curl. |
| Knee room | Smallest modeled vertical thigh/knee clearance under the tabletop in the overlapping region. |
| Unreached target | Fingertip distance from the intended key contact when the fixed limb lengths cannot reach it. |
Contact checks approximate the tabletop, deck profile and palm cushion. They do not test every surface of the shell or the ceiling over the music bay. One fingertip per hand is solved; the other fingers are illustrative. Small surface intersections and unmodeled contacts still need a physical check.
References and uncertainty
OSHA’s adult monitor guidance generally describes 50–100 cm viewing distance, the top at or below eye level, and the center about 15–20° down. These appear as adult reference information for children, not pediatric pass/fail boundaries. Readable text size and individual vision matter.
Colored indicators and conflict bands are design heuristics. They are not injury thresholds. The solver models static geometry, not fatigue, muscle force, growth, visual accommodation or movement over time. Dimensions shown in the interface are rounded to whole centimeters and degrees to avoid implying measurement precision.
Use the age wheel for comparison, enter actual height, choose Typing or Music, then use Side view to inspect the fit. Try Manual furniture heights to compare a table and chair you already own. Confirm the eventual design with real users and a physical prototype.
Research and implementation reviewed with actual Claude Opus 5.5 workers at medium effort. Source data, derivations and automated geometry checks are retained in the project’s research files. Updated 5 November 2026.